AUTOMATIC CAMP-ON
AUTOMATIC CAMP-ON
General Description
An incoming Direct Inward Termination (DIT) call which has been terminated to a busy station can be Camped- On automatically. When the busy station becomes idle, the station is automatically called and connected to the camped on incoming trunk call.
Station Application
All stations.
Operating Procedure
No manual operation is required.
Service Conditions
1.Two Camp-On tone patterns are available: one to send a repeated tone at intervals of 4 seconds, and the other is to send the tone once at the time the call is Camped-On. Either one of these patterns can be selected on a system basis during initial programming.
2.The incoming trunk caller receives Ringback tone from the C.O. until answered by the station in the system.
3.Only a single Camp-On from any source to a station is allowed at one time.
4.When Direct In Termination (DIT) calls are directed to a busy station, they can be preprogrammed on a trunk basis to be sent to an Attendant, Trunk Answer any Station (TAS) or automatically Camped-On to the busy station.
5.Camp-On can be set to a station which has set Call Back. Call Back can be set to a party to which Camp- On service has been set. In both of the above cases, Camp-On has priority over Call Back.
6.Camp-On can be set to a station which has set Trunk Queuing – Outgoing. Camp-On has priority over Trunk Queuing – Outgoing.
7.Camp-On can be set to a station which has placed a call on Hold. When the station becomes idle, Camp-On takes priority over the Hold. Hold can be set to a party to which Camp-On has been set.
8.Camp-On service cannot be set to a data line.
9.If a station is busy and already has a Camp-On set to it, the station user must finish their call, receive ringing and then answer the first Camp-On call, prior to receiving Camp-On tone for the incoming DIT call.
| NEAX2000 IVS2 |
Page 58 | Business/Hotel/Data Features and Specifications |
NDA-24271, Issue 1.0 |
