Xerox WorkCentre C226 manual Misfeed in the High Capacity Feeder

High Capacity Feeder

2. Place the paper in the centre of the paper table.

The paper stack must not be higher than the indicator line (up to 3,500 sheets of Xerox standard paper (80 g/ m2 (21 lbs.))

If the paper type was changed, be sure to change the appropriate settings as explained in “Setting the paper type (except the Bypass Tray)” (See page 1-33).

3. Push the tray firmly all the way into the machine.

The paper table will automatically rise to the paper feed position.

Misfeed in the High Capacity Feeder

When a misfeed occurs in the High Capacity Feeder, remove the misfed paper, follow- ing the procedure below.

1.While holding the tray release lever, carefully slide the High Capacity Feeder away from the main unit until it stops.

Release lever

2. Remove any misfed paper from the main unit and the High Capacity Feeder.

Upper right side cover

If the misfed paper is stuck inside the machine and cannot be removed, open the side cover and then remove the misfed paper. (See “Misfeed in the transport area, fusing area, and exit area” on page 1-49.)

Xerox WorkCentre C226 User Guide 1-75