Xerox WorkCentre C226 manual Peripheral Devices, Saddle Stitch Finisher, Part names and functions

Saddle Stitch Finisher

Peripheral Devices

This section explains procedures for using the peripheral devices such as the Saddle Stitch Finisher.

Saddle Stitch Finisher

The Saddle Stitch Finisher can automatically place two staples for centreline binding of prints or copies and fold them along the centreline. An optional hole punching unit is available for installation into the finisher.

Part names and functions

Stapler compiler Paper to be stapled is stacked temporarily.

When printing on post cards or envelopes, remove the output from here.

Offset tray Output which is stapled or offset will be delivered to this tray.

Saddle stitch tray Saddle stitched output is delivered here.

Top cover Open for misfeed removal.

Stapler section Open the front cover and pull out this section to replace the staple cartridge or to remove jammed staples.

Front cover Open to replace the staple cartridge, to remove the misfed paper, or to remove jammed staples.

NOTES: • Do not press on the Saddle Stitch Finisher (particularly the offset tray).

•Use caution when near the offset tray during printing as the tray moves up and down.

•To install the Saddle Stitch Finisher, a Duplex Bypass/Inverter Unit and either a stand/1-Tray Unit, a 3-Tray Unit, or a Duplex Module/2-Tray Unit must also be installed.

Xerox WorkCentre C226 User Guide 1-59