Xerox WorkCentre C226 manual Using a Program, Programming Frequently Used Operations

Programming Frequently Used Operations

The following settings can be stored in a program:

•Destination fax number

•Polling

•Dual Page Scan

•Resolution and exposure

Auto-dial keys (one-touch or group keys) are used to store the destination fax number. A full number cannot be entered using the numeric keys. When storing a broadcast transmission or serial polling operation in a program, up to 100 destination fax num- bers can be stored.

NOTES: • A program differs from a timer transmission in that it is not cleared from memory after transmission takes place. A program thus allows you to repeatedly perform the same type of transmission. Note, however, that programs do not allow you to establish a timer setting for transmission.

•With the exception of polling, reception operations cannot be stored in a program.

Using a Program

1. In fax mode, load the document.

/

Do not load a document if you are performing a polling operation.

If you are going to use Dual Page Scan, place the docu- ment on the document glass.

2. Touch the [SPECIAL MODES] key and then the [PROGRAM] key.

Special Modes Address Review

Polling

Dual Page

If the address directory screen appears, touch the [CON- DITION SETTINGS] key to display the condition settings screen.

Scan

Program

3.Touch the program key you wish to execute. Make sure the key is highlighted and then touch the [OK] key.

		The program key you touched is selected and you return
	Ok	to the screen of step 2.
		The [PROGRAM] key is highlighted.
g.
ram1

Xerox WorkCentre C226 User Guide 5-45