Xerox WorkCentre C226 manual Changing the paper size in Paper Tray

General Information

4. Set the paper type.

If you change the paper type, be sure to set the paper type refer to “Setting the paper type (except the Bypass Tray)” on page 1-33.

NOTE: If you load a different size of the same type of paper, you only need to change the position of the size slide (see step 2 below); you do not need to change the paper type.

5. Loading paper in Paper Tray 1 is now complete.

Changing the paper size in Paper Tray 1

The following paper size settings are available for Paper Tray 1: A3 to A5 (11" x 17" to 8-1/2" x 5-1/2"), and "EXTRA"*1. Use the following procedure to change the size as needed.

*1 This is limited to square or rectangular paper, A3 to A5 (11" x 17" to 8-1/2" x 5-1/2") size.

1.Pull out Paper Tray 1.

If paper remains in the tray, remove it.

2.Adjust the paper size slide to the paper size.

Move the paper size slide right or left to indicate the paper size being loaded.

If a special size paper is loaded in the paper tray, set the size slide to "EXTRA" to inform the machine that a spe- cial size paper has been loaded. (When INCH-based size paper is loaded, move the size slide to "EXTRA".)

Note that setting the size slide to "EXTRA" only informs the machine that a special size of paper has been loaded; it does not inform the machine of the specific size. If you wish to inform the machine of the specific size, follow the steps in “Setting the paper size when an extra size is loaded” on page 1-

34. (If you do not set a size, part or all of the image may not print.)

3.Adjust the guide plates A and B by squeezing their lock levers and sliding them to the paper size to be loaded.

The guide plates A and B are slidable. Adjust them to the paper size to be loaded while squeezing their lock levers.

1-22 Xerox WorkCentre C226 User Guide