Xerox WorkCentre C226 manual Troubleshooting Saddle Stitch Finisher problems

General Information

15. Push the Saddle Stitch Finisher back against the main unit.

Troubleshooting Saddle Stitch Finisher problems

Check the list below before calling for service.

Problem	Check	Solution or cause
Stapling position is		Check the stapling position setting. (See
not correct (includ-	Stapling position not set properly?
		pages 1-72and 1-73.)
ing saddle stitch).
The Saddle Stitch	Are any Saddle Stitch Finisher covers	Close all covers. (See pages 1-68 and 1-
Finisher does not	open?	69.)
operate.
	Message indicating need to remove	Remove all remaining paper from the
	paper from the stapler compiler dis-	stapler compiler referring to step 4 on
	played?	page 1-63.
	Message to check the staple unit dis-	Remove jammed staples. (See page 1-
	played?	63.)
	Message to add staples displayed?	Replace the staple cartridge. (See
		page 1-61.)Check that a staple cartridge
Stapling cannot be		has been installed. (See page 1-61.)
	Different size paper included?	Stapling cannot be performed onto differ-
performed (includ-
ing saddle stitch).		ent size paper.
	Is the paper badly curled, preventing sta-	Differences in paper quality and type
	pling?	may result in bad curling of output paper.
		Take the paper out of the tray or Bypass
		Tray, turn it around, and reload it so that
		the top and bottom edges are reversed.
The punch hole	The punch function is not set to the cor-	Check the allowed hole punch positions.
positions are not	rect punch positions.
correct*1

1-70 Xerox WorkCentre C226 User Guide