Xerox WorkCentre C226 Important Safety Information, Fax power switch, Settings and programming

Fax Unit

Fax power switch

When using the machine, be sure to keep the fax power switch turned on at all times. The fax power switch must be turned on to receive faxes at night or send timer trans-

mission faxes at night.

ON

OFF

Fax power switch

Settings and programming

Information about settings and programming that are required before the fax function- ality can be used is located in “Points to Check and Program After Installation” on page 5-3 of this manual. Please read this section and perform the required settings and programming.

Lithium battery

A lithium battery inside the machine keeps key operator program settings for the fax function in memory.

When the battery dies, settings and programmed information will be lost. Be sure to keep a written record of the settings and programmed information. (Refer to page 5- 89.)

The life of the lithium battery is approximately 5 years if the machine power switch and fax power switch are kept continually off.

Other information

If a thunderstorm occurs, we recommend that you unplug the power cord from the power outlet. Information will be retained in memory even if the power cord is unplugged.

Important Safety Information

•If any of your telephone equipment is not operating properly, you should immedi- ately remove it from your telephone line, as it may cause harm to the telephone network.

•The AC power outlet shall be installed near the equipment and shall be easily accessible.

•Never install telephone wiring during a lightning storm.

•Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

•Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.

5-2 Xerox WorkCentre C226 User Guide