Xerox WorkCentre C226 manual Using the Dadf, Using the document glass

Sending a Fax

Using the DADF

7. Press the [BLACK COPY START] key.

Scanning begins.

If there are no previous jobs in progress and the line is free, the machine will dial the receiving machine and begin transmission as soon as the first page is scanned. Transmission will take place while any remaining pages are scanned (See “Quick On-line” on page 5-24).

If there is a previously stored job or a job is in progress, or if the line is being used, all pages of the document are scanned into memory and stored as a transmission job. (This is called memory transmission: the destination is automatically called and the document transmitted after previously stored jobs are completed.)

If scanning is completed normally, the machine makes a beep sound to inform you that the transmission job is stored and "JOB STORED." appears in the message display.

Using the document glass

7. Press the [BLACK COPY START] key.

The original is scanned and the [READ-END] key appears in the touch panel.

8.If you have another page to scan, change pages and then press the [BLACK COPY START] key.

Repeat this sequence until all pages have been scanned. You can change the resolution and exposure settings as needed for each page (see pages 5-15 and 5- 17).

If the [BLACK COPY START] key is not pressed within approximately one minute, scanning will end automatically and the transmission will be stored.

9.After the last page is scanned, touch the [READ-END] key.

al. (Pg.No.2)

ess [Read-End]

Read-End

The machine makes a beep sound to inform you that the transmission job is stored and "JOB STORED." appears in the message display. (The destination is automatically called and the document transmitted after previously stored jobs are completed.) Open the document glass cover and remove the document.

Xerox WorkCentre C226 User Guide 5-21