F216 | F217 |
RX Speed Reference Setpoint #1 (%)
Program ⇒ Frequency Setting Parameters ⇒ Speed Reference Setpoints ⇒ RX
This parameter is used to set the direction, gain, and bias of the RX input terminal when this terminal is used as the control input while operating in the Speed Control or the Torque Control mode.
Perform the following setup to allow the system to receive control input at the RX input terminal:
•Program ⇒ Fundamental Parameters ⇒ Standard Mode Selection ⇒ Command Mode ⇒ Use Control Terminal Strip.
•Program ⇒ Fundamental Parameters ⇒ Standard Mode Selection ⇒ Frequency Mode #1⇒ Use RX.
•Provide a Run command (F or R).
Gain and Bias Settings
When operating in the Speed Control mode, the settings that determine the direction, gain, and bias of the RX terminal are:
•RX Speed Reference Setpoint #1 (frequency) (F217),
•the RX input signal level that represents RX Speed Reference Setpoint #1 (frequency): F216,
•RX Speed Reference Setpoint #2 (frequency) (F219), and
•the RX input signal level that represents RX Speed Reference Setpoint #2 (frequency): F218.
When operating in the Torque Control mode, the settings that determine the direction, gain, and bias of the RX terminal are:
•RX Torque Reference Setpoint #1 (%) (F220),
•the RX input signal level that represents the RX Torque Reference Setpoint #1 (%): F216,
•RX Torque Reference Setpoint #2 (%) (F221), and
•the RX input signal level that represents the RX Torque Reference Setpoint #2 (%): F218.
Direct Access Number — F216
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum —
Maximum — 100.0
Units — %
Frequency Settings
Torque Settings
Once set, as the RX input voltage changes, the directional information, the output frequency, or the output torque of the drive will vary in accordance with the above settings.
This parameter sets the RX input level that represents RX Reference Setpoint #1 (direction/torque/frequency). This value is entered as
The input signal may be trimmed using F474 (Bias) and F475 (Gain).
RX Speed Reference Setpoint #1 (frequency) | Direct Access Number — F217 |
Program ⇒ Frequency Setting Parameters ⇒ Speed Reference | Parameter Type — Numerical |
Setpoints ⇒ RX | Factory Default — 0.0 |
This parameter is used to set the direction, gain, and bias of the RX input | Changeable During Run — Yes |
| |
terminal when this terminal is used as the control input while operating in the | Minimum — |
Speed Control mode. | Maximum — +80.0 |
| |
See F216 for further information on this setting. | Units — Hz |
This parameter sets RX Speed Reference Setpoint #1 (frequency) and is the |
|
frequency that is associated with the setting of F216. |
|
G7 ASD Operation Manual | 97 |
