Toshiba G7 manual Accel/Decel Pattern #2, Acc/Dec Group, Acc/Dec Switching Frequency #1

F503			F507
	Accel/Decel Pattern #2	Direct Access Number —	F503
	Program ⇒ Special Control Parameters ⇒ 1 – #4 Settings	Parameter Type — Selection List
	This parameter enables a user-selected preprogrammed output profile that	Factory Default — Linear
		Changeable During Run — Yes
	controls the acceleration and deceleration pattern for the #2 Accel/Decel
	parameter.
	Settings:
	Linear
	S-Pattern 1
	S-Pattern 2
	Acc/Dec Group	Direct Access Number —	F504
	No path available (Direct Access Only)	Parameter Type — Selection List
	While operating using the LED Keypad Option this parameter selects the	Factory Default — 1
		Changeable During Run — Yes
	accel/decel profile to be used during a multiple-accel/decel profile
	configuration. The accel/decel setting for selections 1 – 4 may be found at
	F009, F500, F510, and F514, respectively.
	Settings:
	Group 1
	Group 2
	Group 3
	Group 4
	Note: If using the LCD EOI, press ESC from the Frequency
	Command screen to access this parameter.
	Acc/Dec Switching Frequency #1	Direct Access Number —	F505
	Program ⇒ Special Control Parameters ⇒ Accel/Decel Special	Parameter Type — Numerical
	This parameter sets the frequency at which the acceleration control is switched	Factory Default — 0.00
		Changeable During Run — Yes
	from the Accel #1 profile to the Accel #2 profile during a multiple-acceleration
	profile configuration.	Minimum — 0.00
		Maximum — Max. Freq. (F011)
		Units — Hz
	S-Pattern Lower Limit Adjustment	Direct Access Number —	F506
	Program ⇒ Special Control Parameters ⇒ Accel/Decel Special	Parameter Type — Numerical
	Sets the lower limit of S-pattern 1 and 2.	Factory Default — 25.00
		Changeable During Run — Yes
		Minimum — 0.00
		Maximum — 50.00
		Units — %
	S-Pattern Upper Limit Adjustment	Direct Access Number —	F507
	Program ⇒ Special Control Parameters ⇒ Accel/Decel Special	Parameter Type — Numerical
		Factory Default — 25.00

Sets the upper limit frequency of S-pattern 1 and 2.

Changeable During Run — Yes Minimum — 0.00 Maximum — 50.00

Units — %

142 G7 ASD Operation Manual