Frequency Control
Selections
The following is a listing and description of the
Frequency Mode (F003) selections (Program ⇒
Fundamental Parameters ⇒ Standard Mode Selection
⇒Frequency Mode #1).
Settings:
Use VI/II
0 to
II(cannot use both simultaneously).
Use RR
0 to
Use RX
Use Option Card RX2
Use LED Keypad Option
The LED Keypad is unavailable at the time of this release.
Use Binary/BCD Input
Allows for discrete terminal input to control the ASD output.
Use Common Serial (TTL)
To use the EOI for control requires that the LCD Port Connection be set to Common Serial (TTL) to use this feature.
Use RS232/RS485
To use the EOI for control requires that the LCD Port Connection be set to RS232/RS485 to use this feature.
Use Communication Card
Routes the control and monitoring I/O to CNU3 of the Control Board of the G7 ASD (Option Card connector).
Use Motorized Pot Simulation
A discrete terminal may be configured to increase or decrease the speed of the motor by momentarily connecting the assigned terminal to CC. See Table 8 on page 76 for further information on this feature.
Use Pulse Input Option
Configures the system to receive pulse input. See PG Speed Reference Setpoint on pg. 103 for further information on this feature.
G7 ASD Operation Manual | 35 |
