Toshiba manual G7 Optional Devices, Device Function, ASD Multicom Option Boards

G7 Optional Devices

The ASD may be equipped with several options which are used to expand the functionality of the ASD. Table 22 lists the available options and their functions.

Table 22. G7 Optional devices and functions.

Item		Device Function
ASD7-SIM2	Emulates the input control signals of the G7 ASD via switches and pots.
ASD-BPC	Provides dust protection for the G7 ASD when the EOI is removed or mounted remotely.
ASD-CAB-PC	Female 9-pin d-type to RJ-45 (PC to ASD cable).
ASD-EOI-N4	A replacement NEMA-4 EOI (without Rotary Encoder)
ASD-ISO-1	Provides isolation of the Control Board output circuit from the AM/FM output and
	from the II input.
ASD-MTG-KIT	EOI Remote Mounting Kit. See the section titled EOI Remote Mounting on pg. 190 for
	further information on this option.
ASD-RTC	The Real Time Clock provides the user with a time stamp of the Start, Run, and Fault
	events.
	This option board is used to provide a hardware-based speed search function.
	Note:	The ASD-SS is a factory-authorized service center-installed option for
ASD-SS		all 1 – 5 HP ASDs, 10 – 25 HP 230 volt ASDs, and 15 – 40 HP 460
		volt ASDs (see F314).
	Note:	On ASDs that are rated at 50 HP and above, the ASD-SShardware
		option cannot be used if using a shaft-mounted encoder.
ASD-TB1-AC1	Provides 120 VAC discrete terminal activation and additional I/O terminals.
Conduit
Extender Box	Provides more working space for conduit installation than the standard conduit plate.
(option)
	Provides rotational speed and/or directional information. The Encoder is mounted on the
	motor shaft or the shaft-driven equipment.
HS35 Encoder	Note: On ASDs that are rated at 50 HP and above, the ASD-SS(Speed
		Search) hardware option board cannot be used if using a shaft-
		mounted encoder.
		ASD – Multicom Option Boards
Note:	Multicom boards are identified as ASD-Multicom-A, -B, -F, etc.
-A	Incorporates the Modbus, Profibus, or Device Net communications protocol for system
	control and is able to receive and process Vector Control feedback.
-B	Provides a line driver and open collector interface for system control.
-F	The Tosline-F10interface provides high-speed communication to Toshiba control
	equipment via twisted pair wiring.
-J	Able to receive and process vector control feedback via line driver or open collector
	interface.
-S	The Tosline-S20interface provides high-speed communication to Toshiba control
	equipment via fiber optics.
-X	Provides extended terminal I/O functions for monitoring, feedback, and control.
Note:	See the user manual of the applicable option for further information on each item.

200 G7 ASD Operation Manual