Toshiba manual EOI Operation, G7 Electronic Operator Interface

Rotary Encoder — Functions as the Up key, the Down key, and the Enter key. Turn the Rotary Encoder either clockwise or counterclockwise to perform the Up or Down key functions. Press the Rotary Encoder to perform the Enter function. Simultaneously pressing and turning the Rotary Encoder performs a user-defined function (see Program ⇒ EOI Option Setup ⇒ Preferences ⇒ Encoder Action).

MON/PRG (Monitor/Program) — Provides a means to access the three root menus. Pressing the MON/ PRG key repeatedly loops the system through the three root menus (see Figure 21 on pg. 43). While looping through the root menus, the Program menu will display the last menu screen or sub-menu item being accessed at the time that the MON/PRG key was pressed.

Figure 19. The G7 Electronic Operator Interface.

	LCD Display
	Enter Key
Local/Remote	Up/Down Arrow
	Keys
Key (LED)
Monitor/Program	Rotary Encoder
Key
Run Key
(LED)	Esc Key
	StopReset Key

EOI Operation

The EOI is the primary input/output device for the user. The EOI may be used to monitor system functions, input data into the system, or perform diagnostics.

Note: The Up/Down arrow keys and the Enter key may be used to perform the functions of the Rotary Encoder. The Rotary Encoder will be used in this explanation and throughout this manual for the Up, Down, and Enter key functions.

The software used with the G7 is menu driven; thus, making it a select and click environment. The operating parameters of a motor may be selected and viewed or changed using the EOI.

To change a parameter setting, go to the Program mode by pressing the MON/PRG key until the Program menu is displayed. Turn the Rotary Encoder until the desired parameter group is within the cursor block. Press the Rotary Encoder (repeat if there is a submenu).

The selection will take on the reverse video format (dark background/light text). Turn the Rotary Encoder to change the value of the parameter. Press the Esc key while the display is in the reverse video mode to exit the menu without saving the change or press the Rotary Encoder to accept the new setting.

Repeated Esc key entries takes the menu back one level each time the Esc key is pressed until the root level is reached. After reaching the root level, continued Esc entries will toggle the system to and from the Frequency Command screen and the Panel menu.

Note: Panel menu changes entered here will affect EOI-controlled ASD operation only. LED Keypad-controlled functions will not be affected. LED Keypad-controlled operation settings may be viewed or changed at F008. See the section titled Panel Menu on pg. 44 for further information on Panel Menu operations.

G7 ASD Operation Manual 37