84 G7 ASD Operation Manual
OUT6 On DelayProgram ⇒ Terminal Selection Parameters ⇒ Output Terminal Dela ys
⇒ OUT6
This parameter delays the closing of the OUT6 output terminals by the
programmed value (see waveforms at F150).
The delay may be i ncreased to preve nt relay chatter.
Direct Access Number — F155
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
OUT7 On DelayProgram ⇒ Terminal Selection Parameters ⇒ Output Terminal Dela ys
⇒ OUT7
This parameter delays the closing of the OUT7 output terminals by the
programmed value (see waveforms at F150).
The delay may be i ncreased to preve nt relay chatter.
Direct Access Number — F156
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
OUT1 Off DelayProgram ⇒ Terminal Selection Parameters ⇒ Output Terminal Dela ys
⇒ OUT1
This parameter delays the opening of the OUT1 (A & C) output terminals by
the programmed value.
The delay may be increased to allow the devices that are connected to OUT1 to
respond.
Direct Access Number — F160
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
OUT2 Off DelayProgram ⇒ Terminal Selection Parameters ⇒ Output Terminal Dela ys
⇒ OUT2
This parameter delays the opening of the OUT2 (A & C) output terminals by
the programmed value (see waveforms at F160).
The delay may be increased to allow the devices that are connected to OUT2 to
respond.
Direct Access Number — F161
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
FL Off DelayProgram ⇒ Terminal Selection Parameters ⇒ Output Terminal Dela ys
⇒ FL
This parameter delays the opening of the FL output terminals by the
programmed value (see waveforms at F160).
The delay may be increased to allow the devices that are connected to FL to
respond.
Direct Access Number — F162
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
F155 F162