G7 ASD Operation Manual 75
Input Terminal 14 Assignment
Program ⇒ Terminal Selection Parameters ⇒ Input Terminal
Assignment ⇒ 14
This parameter selects the functionality of the #14 input terminal.
Note: The #14 input terminal may be used without the ASD-Multicom
option board.
Without the ASD-Multicom option board the #14 terminal
assignment informati on will be stored in v olatile memory. The
terminal assignment i nformation will be los t if the system is
powered down or reset.
In addition, the input t erminal must be spec ified as Normally Open or
Normally Closed.
This parameter sets t he programmable ter minal #14 to 1 of the 68 possible
functions that are listed in Table 8 on pg. 76.
Direct Access Number — F124
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Input Terminal 15 Assignment
Program ⇒ Terminal Selection Parameters ⇒ Input Terminal
Assignment ⇒ 15
This parameter selects the functionality of the #15 input terminal.
Note: The #15 input terminal may be used without the ASD-Multicom
option board.
Without the ASD-Multicom option board the #15 terminal
assignment informati on will be stored in v olatile memory. The
terminal assignment i nformation will be los t if the system is
powered down or reset.
In addition, the input t erminal must be spec ified as Normally Open or
Normally Closed.
This parameter sets t he programmable ter minal #15 to 1 of the 68 possible
functions that are listed in Table 8 on pg. 76.
Direct Access Number — F125
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Input Terminal 16 Assignment
Program ⇒ Terminal Selection Parameters ⇒ Input Terminal
Assignment ⇒ 16
This parameter selects the functionality of the #16 input terminal.
Note: The #16 input terminal may be used without the ASD-Multicom
option board.
Without the ASD-Multicom option board the #16 terminal
assignment informati on will be stored in v olatile memory. The
terminal assignment i nformation will be los t if the system is
powered down or reset.
In addition, the input t erminal must be spec ified as Normally Open or
Normally Closed.
This parameter sets t he programmable ter minal #16 to 1 of the 68 possible
functions that are listed in Table 8 on pg. 76.
Direct Access Number — F126
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
F124 F126