F801 |
| F803 |
|
|
|
Parity | Direct Access Number — | F801 |
Program ⇒ Communication Setting Parameters ⇒ Communication | Parameter Type — Selection List | |
Settings | Factory Default — Even Parity | |
This parameter plays a role in the setup of the communications network by | Changeable During Run — Yes | |
establishing the Parity setting of the communications link. |
|
|
The communications network includes other ASDs and Host/Control computers |
|
|
that monitor the status of the ASD(s), transfers commands, and loads or |
|
|
modifies the parameter settings of the ASD. |
|
|
Changes made to this parameter require that the power be cycled (Off then On) |
|
|
for the changes to take effect. |
|
|
Settings: |
|
|
No Parity |
|
|
Even Parity |
|
|
Odd Parity |
|
|
|
|
|
ASD Number | Direct Access Number — | F802 |
Program ⇒ Communication Setting Parameters ⇒ Communication | Parameter Type — Numerical | |
Settings | Factory Default — 0 |
|
This parameter plays a role in the setup of the communications network by | Changeable During Run — Yes | |
assigning an identification (ID) number to each ASD in the communications | Minimum — 0 |
|
network. |
| |
Maximum — 255 |
| |
The communications network includes other ASDs and Host/Control computers |
| |
|
| |
that monitor the status of the ASD(s), transfers commands, and loads or |
|
|
modifies the parameter settings of the ASD. |
|
|
Changes made to this parameter require that the power be cycled (Off then On) |
|
|
for the changes to take effect. |
|
|
|
|
|
RS232/RS485 Communications Time Out Time | Direct Access Number — | F803 |
Program ⇒ Communication Setting Parameters ⇒ Communication | Parameter Type — Numerical | |
Settings | Factory Default — 0 |
|
This parameter plays a role in the setup of the communications network by | Changeable During Run — Yes | |
setting the time that no activity may exist over the communications link before | Minimum — 0 |
|
the link is severed (Time Out). |
| |
Maximum — 100 |
| |
The communications network includes other ASDs and Host/Control computers |
| |
Units — Seconds |
| |
that monitor the status of the ASD(s), transfers commands, and loads or |
| |
modifies the parameter settings of the ASD. |
|
|
Changes made to this parameter require that the power be cycled (Off then On) for the changes to take effect.
168 | G7 ASD Operation Manual |