Toshiba G7 manual ST Input Terminal Delay, RES Input Terminal Delay, S1 S4 Input Terminal Delay

F141		F145
R Input Terminal Delay	Direct Access Number —	F141
Program ⇒ Terminal Selection Parameters ⇒ Input Terminal Delays ⇒	Parameter Type — Numerical
R	Factory Default — 8.0
This parameter delays the response of the drive to any change in the R terminal	Changeable During Run — No
input by the programmed value (see waveforms at F140).	Minimum — 2.0
The delay may be increased to provide additional electrical noise immunity or	Maximum — 200.0
to prevent the ASD from responding to contact bounce or chatter.	Units — mS
ST Input Terminal Delay	Direct Access Number —	F142
Program ⇒ Terminal Selection Parameters ⇒ Input Terminal Delays ⇒	Parameter Type — Numerical
ST	Factory Default — 8.0
This parameter delays the response of the drive to any change in the ST	Changeable During Run — No
terminal input by the programmed value (see waveforms at F140).	Minimum — 2.0
The delay may be increased to provide additional electrical noise immunity or	Maximum — 200.0
to prevent the ASD from responding to contact bounce or chatter.	Units — mS
RES Input Terminal Delay	Direct Access Number —	F143
Program ⇒ Terminal Selection Parameters ⇒ Input Terminal Delays ⇒	Parameter Type — Numerical
RES	Factory Default — 8.0
This parameter delays the response of the drive to any change in the RES	Changeable During Run — No
terminal input by the programmed value (see waveforms at F140).	Minimum — 2.0
The delay may be increased to provide additional electrical noise immunity or	Maximum — 200.0
to prevent the ASD from responding to contact bounce or chatter.	Units — mS
S1 – S4 Input Terminal Delay	Direct Access Number —	F144
Program ⇒ Terminal Selection Parameters ⇒ Input Terminal Delays ⇒	Parameter Type — Numerical
S1 – S4	Factory Default — 8.0
This parameter delays the response of the drive to any change in the S1 – S4	Changeable During Run — No
terminal input by the programmed value (see waveforms at F140).	Minimum — 2.0
The delay may be increased to provide additional electrical noise immunity or	Maximum — 200.0
to prevent the ASD from responding to contact bounce or chatter.	Units — mS
S5 – S16 Input Terminal Delay	Direct Access Number —	F145
Program ⇒ Terminal Selection Parameters ⇒ Input Terminal Delays ⇒	Parameter Type — Numerical
S5 – S16	Factory Default — 8.0
This parameter delays the response of the drive to any change in the S5 – S16	Changeable During Run — No
terminal input by the programmed value (see waveforms at F140).	Minimum — 2.0
The delay may be increased to provide additional electrical noise immunity or	Maximum — 200.0
to prevent the ASD from responding to contact bounce or chatter.	Units — mS

82 G7 ASD Operation Manual