F723

F732

Torque Limit Group

No path available (Direct Access Only)

While operating using the LED Keypad Option this parameter is used to select 1 of 4 preset positive torque limits to apply to the active motor. The settings of profiles 1 – 4 may be setup at F441, F444, F446, and F448, respectively.

Settings:

1

2

3

4

Note: If using the LCD EOI, press ESC from the Frequency Command screen to access this parameter.

Direct Access Number — F723

Parameter Type — Selection List

Factory Default — 1

Changeable During Run — Yes

Feedback in Panel Mode

No path available (Direct Access Only)

While operating using the LED Keypad Option this parameter Enables/ Disables PID feedback control.

Settings:

Enabled

Disabled

Direct Access Number — F724

Parameter Type — Selection List

Factory Default — Enabled

Changeable During Run — Yes

Note: If using the LCD EOI, press ESC from the Frequency Command screen to access this parameter.

LED Option Override Multiplication Gain

Program Feedback Parameters Override Control

If operating using the LED Keypad Option this parameter provides a value to be used in the event that Setting is selected for the Frequency Override

Multiplying Input (F661).

Direct Access Number — F729

Parameter Type — Numerical

Factory Default — 0.00

Changeable During Run — Yes

Minimum — -100.00

Maximum — 100.00

LOD Control and Stopping Method

Direct Access Number — F731

Program Special Control Parameters Low Output Disable Function

Parameter Type — Selection List

LOD

Factory Default — Disabled

Enables/Disables the Low Output Disable function and, if enabled, selects a

Changeable During Run — Yes

 

stopping method.

 

Settings:

 

Disabled

 

Enabled — Decel Stop

 

Enabled — Coast Stop

 

 

 

LOD Start Level (Hz)

Direct Access Number — F732

Program Special Control Parameters Low Output Disable Function

Parameter Type — Numerical

LOD Start Level (Hz)

Factory Default — 0.0

The Low Output Disable Start Level sets the output frequency threshold that,

Changeable During Run — Yes

 

if exceeded, will initiate the LOD function if properly configured.

Minimum — 0.0

Maximum — Max. Freq.

Units — Hz

166

G7 ASD Operation Manual

Page 172
Image 172
Toshiba G7 manual Torque Limit Group, Feedback in Panel Mode, LED Option Override Multiplication Gain, LOD Start Level Hz