Toshiba G7 manual BIN Torque Reference Setpoint #2 %, PG Speed Reference Setpoint #1 %

F233		F234
BIN Torque Reference Setpoint #2 (%)	Direct Access Number —	F233
Program ⇒ Torque Setting Parameters ⇒ Setpoints ⇒ BIN	Parameter Type — Numerical
This parameter is used to set the direction, gain, and bias of the BIN binary input	Factory Default — +100.0
	Changeable During Run — Yes
terminals when these terminals are used as the control input while operating in
the Torque Control mode.	Minimum — -250.0
This is accomplished by establishing an associated V/f output pattern for a given	Maximum — +250.0
BIN binary input and motor load.	Units — %
See F232 for further information on this setting.
This parameter sets BIN Torque Reference Setpoint #2 (%) and is entered as
-250 to +250% of the rated torque.
PG Speed Reference Setpoint #1 (%)	Direct Access Number —	F234
Program ⇒ Frequency Setting Parameters ⇒ Speed Reference	Parameter Type — Numerical
Setpoints ⇒ PG	Factory Default — 0.0
This parameter is used to set the direction, gain, and bias of the PG input	Changeable During Run — Yes
terminal when it is used as the Speed/Direction control input. The PG input	Minimum — -100.0
signal is a pulse count originating from a shaft-mounted Encoder.	Maximum — +100.0
Note: The PG input terminal may be used with the ASD-Multicom	Units — %
option board only.	Frequency Settings

Perform the following setup to allow the system to receive a binary control input:

•Program ⇒ Fundamental Parameters ⇒ Standard Mode Selection ⇒ Command Mode ⇒ (any setting).

•Program ⇒ Fundamental Parameters ⇒ Standard Mode Selection ⇒

Frequency Mode #1⇒ Use Pulse Input Option.

• Provide a Run command (F or R).

The settings that determine the direction, gain, and bias of the PG input are:

•PG Speed Reference Setpoint #1 (frequency) (F235),

•the PG input pulse count that represents PG Speed Reference Setpoint #1 (frequency): F234,

•PG Speed Reference Setpoint #2 (frequency) (F237), and

•the PG input pulse count that represents PG Speed Reference Setpoint #2 (frequency): F236.

Once set, as the PG input pulse count changes, the directional information or the output frequency of the drive will vary in accordance with the above settings.

This parameter sets the PG input pulse count that represents Reference Setpoint #1 (frequency) (direction/speed). The range of values for this parameter is -100 to +100% of the PG input pulse count range.

Note: Further application-specific PG settings may be performed from the following path: Program ⇒ Feedback Parameters ⇒ PG Settings.

G7 ASD Operation Manual 103