Toshiba G7 manual EOI Remote Mounting, Remote EOI Required Hardware

EOI Remote Mounting

The G7 ASD may be controlled from a remotely-mounted EOI. For safety and application-specific reasons, some ASD installations will warrant that the operator not be in the vicinity during operation or that the EOI not be attached to the ASD housing. The EOI may be mounted either with or without the optional G7 Remote Mounting Kit (P/N ASD-MTG-KIT). The ease of installation is enhanced by the G7 Remote Mounting Kit which allows for easier cable routing and EOI placement.

The EOI can operate up to distances of 15 feet from the ASD via the Common Serial (TTL) Port. For distances beyond 15 feet, the RS232/RS485 port is recommended.

Remote mounting will also allow for multiple EOI mountings at one location if controlling and monitoring several ASDs from a central location is required.

The optional dust cover (P/N ASD-BPC) may be used to cover the front panel opening of the ASD housing after removing the EOI. An EOI extender cable is required for remote mounting. EOI extender cables are available in lengths of 7, 10, or 15 feet and may be ordered through your sales representative.

Remote EOI Required Hardware

EOI Mounting Hardware

•6-32 x 5/16” Pan Head Screw — P/N 50595 (4 ea.)

•#6 Split-Lock Washer — P/N 01884 (4 ea.)

•#6 Flat Washer — P/N 01885 (4 ea.)

Bezel Plate Mounting Hardware

•Bezel Plate — P/N 52291

•10-32 Hex Nut — P/N 01922 (4 ea.)

•#10 Split-Lock Washer — P/N 01923 (4 ea.)

•#10 Flat Washer — P/N 01924 (4 ea.)

•Dust Cover — P/N ASD-BPC (Optional)

Extender Cables

•ASD-CAB7F: Cable, RJ45, 7 ft.

•ASD-CAB10F: Cable, RJ45, 10 ft.

•ASD-CAB15F: Cable, RJ45, 15 ft.

190 G7 ASD Operation Manual