Toshiba G7 manual Pattern #12 Characteristics Pattern Run, Pattern #13 Characteristics Pattern Run

F581	F588
Pattern #12 Characteristics (Pattern Run)	Direct Access Number — F581
Program ⇒ Pattern Run Control Parameters ⇒ Preset Speeds ⇒ 12	Parameter Type — Selection List
Same as #1 Pattern Characteristics (see F570).	Factory Default — Time From Start
	Changeable During Run — No
Pattern #13 Characteristics (Pattern Run)	Direct Access Number — F582
Program ⇒ Pattern Run Control Parameters ⇒ Preset Speeds ⇒ 13	Parameter Type — Selection List
Same as #1 Pattern Characteristics (see F570).	Factory Default — Time From Start
	Changeable During Run — No
Pattern #14 Characteristics (Pattern Run)	Direct Access Number — F583
Program ⇒ Pattern Run Control Parameters ⇒ Preset Speeds ⇒ 14	Parameter Type — Selection List
Same as #1 Pattern Characteristics (see F570).	Factory Default — Time From Start
	Changeable During Run — No
Pattern #15 Characteristics (Pattern Run)	Direct Access Number — F584
Program ⇒ Pattern Run Control Parameters ⇒ Preset Speeds ⇒ 15	Parameter Type — Selection List
Same as #1 Pattern Characteristics (see F570).	Factory Default — Time From Start
	Changeable During Run — No
Pattern Run #1 Run-Time Setting	Direct Access Number — F585
Program ⇒ Pattern Run Control Parameters ⇒ Preset Speeds ⇒ 1	Parameter Type — Numerical
This parameter sets the run-time value for the #1 Preset Speed mode when	Factory Default — 5
	Changeable During Run — No
used as part of a Pattern Run.
	Minimum — 1
	Maximum — 8000
	Units — Seconds

Pattern Run #2 Continuation Mode Run-Time Setting

Program ⇒ Pattern Run Control Parameters ⇒ Preset Speeds ⇒ 2

This parameter sets the run-time value for the #2 Preset Speed mode when used as part of a Pattern Run.

Direct Access Number — F586

Parameter Type — Numerical

Factory Default — 5

Changeable During Run — No

Minimum — 1

Maximum — 8000

Units — Seconds

Pattern Run #3 Run-Time Setting

Program ⇒ Pattern Run Control Parameters ⇒ Preset Speeds ⇒ 3

This parameter sets the run-time value for the #3 Preset Speed mode when used as part of a Pattern Run.

Direct Access Number — F587

Parameter Type — Numerical

Factory Default — 5

Changeable During Run — No

Minimum — 1

Maximum — 8000

Units — Seconds

Pattern Run #4 Run-Time Setting

Program ⇒ Pattern Run Control Parameters ⇒ Preset Speeds ⇒ 4

This parameter sets the run-time value for the #4 Preset Speed mode when used as part of a Pattern Run.

Direct Access Number — F588

Parameter Type — Numerical

Factory Default — 5

Changeable During Run — No

Minimum — 1

Maximum — 8000

Units — Seconds

G7 ASD Operation Manual 151