Toshiba G7 manual System Configuration and Menu Options, Root Menus, Frequency Command Mode

System Configuration and Menu Options

Root Menus

The MON/PRG key accesses the three primary modes of the G7: the Frequency Command mode, the Monitor mode, and the Program mode. From either mode, press the MON/PRG key to loop through to the other two modes (see Figure 21). While in the Frequency Command mode, pressing the ESC key toggles the menu to and from the Panel menu and the Frequency Command mode.

Note: Panel menu changes made when accessing the Panel menu using the method shown in Figure 21 is effective for Local LCD EOI control Only.

Figure 21. Root menu mapping.

Frequency Command Mode

Frequency Setting

While operating in the Local mode (Local LED is illuminated on the front panel), the running frequency of the motor may be set from the Frequency Command screen. Using the Rotary Encoder, enter the Frequency Command value and then press the Run key. The motor will run at the Frequency Command speed and may be changed while running.

Scrolling Monitor

The Output Current and the ASD Load values are displayed (default setting) below the Frequency Command parameter of the Frequency Command screen. Other user-selected parameters may be displayed on this screen for quick-access monitoring while running. These parameters may be accessed and enabled for display by placing a check in the box next to the item listed at Program ⇒ Monitor Setup

⇒Scrolling Monitor Select. If no parameters are enabled for display, No Items is displayed.

When more than two items are selected for display the items are scrolled automatically. The display time for each selected item may be set from 1 to 60 seconds. The parameters that may be displayed on the Scrolling Monitor are listed in the section titled Monitor Mode on pg. 45.

G7 ASD Operation Manual 43