Installing the Operating System with Express Setup 5-15
Setting for Solving Problems
Setup the following issue in advance so that your computer can recover from any trouble precisely and as soon as possible when it should occur.
Memory Dump (Debug Information)
This section describes the procedures for collecting memory dump (debug information) in the server.
IMPORTANT: Cautions for the Memory Dump
The staff of maintenance service representative is in charge of collecting memory dump. Customers need only to specify the memory dump.
If any trouble occur after specifying the process below, the message to inform that the system is in short of virtual memory may appear, but continue to start the system. If you
Follow the procedure below to specify.
1.Select [Control Panel] and click [System]. The [System Properties] dialog box appears.
2.Select [Advanced] tab.
3.Click [Settings] on the [Startup and Recovery] group box.
IMPORTANT:
To specify "Complete Memory Dump" to write the debug information is recommended. If the mounted memory size is larger than 2GB, "Complete Memory Dump" cannot be specified so that specify "Kernel Memory Dump" instead.
Specify the drive where there is a free area more than the size of "the memory capacity mounted on Express server + 12MB".
In case the mounted memory size exceeds 2GB due to the added memory, change the write debugging information to [Kernel Memory Dump] before adding memory. The size of debugging information (memory dump) to be taken also changes due to adding memory.
Verify the size of the empty space in the debugging information (memory dump) write destination drive.
