NEC 140Rc-4 manual CPU Access Cover

Upgrading Your Server 9-23

CPU Access Cover

The CPU access cover provides access to the electronics bay that contains PCI add-in cards and the server board set such as a memory board, processor board.

CAUTION

Observe the following instructions to use the server safely. Failure to follow these instructions may result in death or serious personal injury. See pages 1-3 to 1-8 for details.

■ Do not install the server on a rack with leaving covers removed.

Removal

1.See the section "Preparing for Installation and Removal" described earlier to prepare.

2.Pull out the server from the rack.

3.Remove the rear access cover.

4.Loosen the two captive screws located on the front of the CPU access cover.

5.Lift the end of the cover where the screws are located and remove the cover.

Installation

Follow these steps to install the CPU access cover.

1.Orient the access cover with the captive screws toward the front of the server.

2.Insert the tabs on the rear of the cover into the slots at the rear of the chassis.

3.Press down gently and tighten the captive screws at the front of the cover.

4.Reinstall the removed components.