Upgrading Your Server 9-21

Removal

Remove the device in reverse order of the installation steps.

IMPORTANT:

„To remove a cable from the signal connector, pull out the cable with holding the pull-tab on the cable connector. Pulling out the cable with holding the cable may make some pins bent and/or some internal wires disconnected. This may cause a malfunction to occur

„If you leave the 5.25-inch device bay empty, install a dummy cover on the bay for proper cooling and airflow. Installing a device in the bay or covering the bay with a dummy cover protects the System EMI integrity and cooling. When you install a drive, save the dummy cover to reinstall if you should later remove the drive and not reinstall one in the same bay.

Page 307
Image 307
NEC 140Rc-4 manual Removal