Upgrading Your Server 9-29

12.Reinstall the removed components.

13.Turn on the power of the server. Then make sure that any error message does not appear in POST.

If an error message appears, write down the message and review the error message list in Chapter 8.

14.Start the BIOS Setup Utility to set the "Reset Configuration Data" in the "Advanced" menu to "Yes."

This is required to update the hardware configuration information. See Chapter 4 for details.

Removal

Remove the board in the reverse procedure of the installation. Then install the connector cap and additional slot cover.

Page 315
Image 315
NEC 140Rc-4 manual Removal