NOTE: The operation or utility to be started at each key entry is described below. These operations or utilities may not always be started.
Esc
Press Esc to display the boot menu at the end of POST. This menu allows you to select the device to be started.
Boot Menu
1.
2.+Removable Devices
3.+Hard Drive
4.IBA 4.0.19 Slot 0003
5.IBA 1.0.17 Slot 0103
<Enter Setup>
F2
Press F2 to start the BIOS setup utility. Start the utility to change the setting of the server to that fit to the environment in which the server is used. In general, the setting may not be particularly changed by starting the utility excluding the case in which the previous message accompanying by an error message appears. See Chapter 4 for the setting procedures and features of the parameters.
F4
Press F4 to start the
F12
Press F12 to run the network boot.
F1
If message "Press <F1> to resume" appears, an error is detected during POST. See "Error messages during POST" for the information on the messages and the proper actions against the errors. If an error message appears, pressing F1 allows the BIOS setup utility to be started.
7.When a password is set in the BIOS setup utility SETUP, the screen prompting you to enter the password appears after the normal termination of POST.
The password can be entered for up to three times. If you enter the password incorrectly all the time, the server cannot be started. In this case, turn off the power of the server, wait for about 10 seconds, and then turn on the power to start the server again.
IMPORTANT: Set the password only after OS is installed.
8.Starts OS at the termination of POST.
