General Description 2-7

Rear View

See Chapter 8 for detail information on lamp indication.

1

2

3-1

3-2

4

5

6

7

8

20

13-1

14 15

16

9 10 11 12 13-2

17 18 17 19 21

1AC inlet 1

The AC inlet 1 is connected with the power cord coming with the server.

2AC inlet 2

The AC inlet 2 is used when the additional power supply unit is installed in the server.

3 ICMB-1 (left) ICMB-2 (right) connector

The ICMB connector is connected to a device having the ICMB interface.

4Serial port B connector

The serial port B connector is used to connect the server to a device with the serial interface. The server cannot be directly connected to a leased line through the connector.

For using this port, the rear serial cable that comes with your server should be connected to this connector.

5External SCSI connector

The external SCSI connector is used to connect the server to external SCSI devices. For the connection, attached SCSI cable is necessary and some cable connections must be changed on the baseboard.

6PCI slot power lamp (green) (upper)

The PCI slot power lamp is lit when the power of the PCI slot being on.

6PCI slot fault lamp (amber) (lower)

PCI slot fault lamp blinks when the hot plug PCI function is enabled with Windows 2000. The lamp also goes on if a fault occurs in the PCI board installed into the slot or the slot itself.

7Printer port connector

The printer port connector is connected with a printer with the Centronics interface.

Page 41
Image 41
NEC 140Rc-4 manual Rear View