Setting Up Your Server 3-11

4.Install an inner rail on one side of the server with three screws A in the direction shown in the figure.

Release lever

NOTE: Each inner rail may be used at either of the left and right sides. However, use the proper inner rail to each slide rail assembly from which the rail has been removed so that the direction of the inner rail can be fit to the slide rail assembly.

5.Install the other inner rail on the other side of the server by steps 3 and 4 above.

6.Install handles R and L on the front of the server with four screws B.

NOTE: The left handle is different from the right handle in shape. Check the shape of each handle. The handle (L) has the frame on which the tab of the front bezel is hung.

Handle (L)

Handle (R)

Frame on which tab

is hung

Left side of server

Right side of server

 

 

Page 83
Image 83
NEC 140Rc-4 manual Handle L