Installing and Using Utilities 6-21

Remote Management Configuration for the Server without Console

This subsection describes the procedures for using BIOS SETUP utilities and DOS-based tool on the server with remote console in case that the server is not connected the console like as keyboad. The following two methods are available.

„Through the management PC via LAN

„Through the management PC with direct connection

Through the management PC via LAN

1.Click [Program] - [NEC MWA] - [MWA] from the start menu on the management PC installed NEC MWA.MWA will start and open [Remote Control Manager].

2.Insert a formatted floppy disk of 1.44 MB into the floppy disk drive of the management PC.

3.Select [Configuration] from the [File] menu of [MWA Remote Control Manager] to display the [Configuration] dialog box.

4.Select [New] to display the [Select a model] dialog box.

5.Check [Write data to FD] and select the model name to display the Configuration dialog box for the server.

6.Set and register the configuration information on the [Configuration for BMC] dialog box and then write the configuration information into the floppy disk with the following file name:

<Configuration Information File name>

CSL_LESS.cfg

The setting items of the server are as follows:

Computer Name (The managed server name. Arbitrary.) IP Address

Subnet Mask Default Gateway

Primary Alert Receiver (IP address of management PC)

Page 217
Image 217
NEC 140Rc-4 manual Through the management PC via LAN