NEC 140Rc-4 manual Installing the Windows Server

5-8 Installing the Operating System with Express Setup

Installing the Windows Server 2003

This section describes on how to setup the system using Express Setup.

Prepare Configuration Diskette. You can operate the installation if you do not have Configuration Diskette specified in advance, but one floppy disk formatted by MS-DOS 1.44MB is necessary also in such case. For Configuration Diskette, use the blank disk in NEC EXPRESSBUILDER package or prepare other floppy disk personally.

IMPORTANT:

„If you modified the system configuration, execute "System Update".

„If you want to modify or add Graphics Accelerator Driver or the drivers of Network Adapter and so on, see Appendix D.

1.Turn the power of peripheral device on, and then turn on the server.

2.Insert NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive of the server.

3.Ensure that the floppy disk drive is empty.

4.Press the RESET switch or press Ctrl, Alt, and Delete to reboot from the NEC EXPRESSBUILDER. (You may also turn off and then on again to reboot the server.)

The system will boot from the CD-ROM and NEC EXPRESSBUILDER starts.

5.Click [Express Setup]. "Note" will be displayed.

6.Read the instruction carefully and click [OK].

The message "Insert Configuration Diskette" appears.

7.Insert "Configuration Diskette" into floppy disk drive and click [OK].

NOTE: If you do not have "Configuration Diskette", insert a blank floppy disk formatted by 1.44MB into the floppy disk drive and click [OK].