Upgrading Your Server 9-17
Front Access Cover
To install or remove devices in the
CAUTION
Observe the following instructions to use the server safely. Failure to follow these instructions may result in death or serious personal injury. See pages
■ Do not install the server on a rack with leaving covers removed.
Removal
1.See the section "Preparing for Installation and Removal" described earlier to prepare.
2.Pull out the server from the rack cabinet.
3.Remove the three screws.
4.While lightly pressing down on the cover, slide it toward the front of the server.
5.Lift the cover up and off of the server.
Installation |
IMPORTANT: Before installing the front access cover, check that you have not left tools or loose parts inside the system.
1.Position the cover on the chassis so that the cover tabs align with the chassis slots.
2.While lightly pressing down on the cover, slide it toward the rear of the chassis until the cover tabs fully engage the chassis slots.
3.Attach the cover to the chassis with the three screws removed earlier.
