Upgrading Your Server 9-73

14.Remove the screw located on the bracket of the rear serial cable connector.

15.Hook the bracket of the rear serial cable connector from the inside of the rear face.

16.Fix the serial cable connector from the outside of the rear face with a single screw removed in step 14.

17.Change the settings of the jumpers on the baseboard, if it is necessary. See the jumper positions shown in the figure below.

IMPORTANT: Do not change the other jumper settings. Failure to follow it may cause the unit to be defected or some malfunction to occur.

18.Install the removed parts.

When the cable is reinstalled on the front of the server, route the cable below the guide rail for the PCI board from the position shown in the figure below.

Page 359
Image 359
NEC 140Rc-4 manual Upgrading Your Server