NEC 140Rc-4 manual PCI Hot Plug, Saving the Configuration Data, Code Board name Setting Value

4-8 Configuring Your Server

PCI Hot Plug

To install the PCI board with the PCI hot plug

Select [Advanced] - [PCI Configuration] - [Hot Plug PCI Control] - [Minimum/Middle/Maximum*]

*The setting varies depending on the PCI board subject to the hot plug. See the table below.

N code	Board name	Setting Value
N8104-85F	100BASE-TX Adapter	Minimum
N8104-103F	1000BASE-T Adapter	Minimum

Select [Advanced] - [PCI Configuration] - [Hot Plug PCI Control] - [Empty Bus Default Speed] - [PCI Slots 5-6*]/[PCI Slots 7-8*] and set the frequency of the boards to be installed.

*If the hot plugs are provided for PCI Slot 5-6 or PCI Slot 7-8, previously set the speeds of the slots to meet those of the boards to be installed.

Saving the Configuration Data

To save the BIOS configuration data

Select [Exit] - [Exit Saving Changes] or [Save Changes].

To discard changes to the BIOS configuration data

Select [Exit] - [Exit Discarding Changes] or [Discard Changes].

To resume the default BIOS configuration data (may differ from factory-set value)

Select [Exit] - [Load Setup Defaults].

To save the current value as user default

Select [Exit] - [Save Custom Defaults].

To load the user-defined default

Select [Exit] - [Load Custom Defaults].