8-42 Troubleshooting
RECOVERY FOR Windows 2000
If any file necessary for running the OS is damaged, use the following procedures to recover the system.
IMPORTANT:
After recovering the system, see "Updating the System" in Chapter 5 and be sure to update the system.
Also on Windows 2000, you need to update all the drivers after the system update. For more information, see "Installing and Setting Device Drivers" in Chapter 5.
If the hard disk can not be recognized, you can not recover the system.
Follow the procedure below and use the information in the disk, not system recovery disk, to recover the system.
1.Turn on the power of the system.
2.Insert Windows 2000 CD- ROM into the
3.Press the RESET switch or press Ctrl, Alt, and Delete to reboot the server. (You may also turn off and then on again to reboot the server.)
4.Press F6 while the message "Setup is inspecting your computer's hardware configuration..." is displayed at the upper part of the screen.
NOTE: Nothing is changed on the screen through F6 is pressed.
5.Press S when the following message appears:
Setup could not determine the type of one or more mass storage devices installed in your system, or you have chosen to manually specify an adapter. Currently, Setup will load support for the following mass storage devices.
Select [Other] and press Enter.
6.Insert Windows 2000
Please insert the disk labeled
* Press ENTER when ready.
Select the [Adaptec Ultra320 SCSI Cards (Win2000)] and press Enter.
Then, it returns to the screen of step 5.
