9-38 Upgrading Your Server

5.Push the tab to unlock it, slowly open the tab, then remove the PCI board.

IMPORTANT: Do not open the retention tab to 90 degrees or more.

Doing so could damage the tab.

NOTE: The insulators are installed between the PCI board slots. They are for protecting the PCI board already been installed. Take care not to remove or damage the insulator when installing or removing the PCI board. If the insulator is taken off, reinstall the insulator in place.

Tab

Lock (for long card)

6.Install the dust cover and expansion slot cover on the slot from which you remove the PCI board, then slowly close the tab.

NOTE: Confirm that the PCI Slot Power lamp blinks once, and that the PCI Slot Fault lamp is off. If the PCI Slot Fault lamp is on, open and close the tab again.

IMPORTANT: To maintain the dust-proofing and electromagnetic radiation characteristics and cooling performance of the server, be sure to install the dust cover and the expansion slot cover on the slot from which you removed the PCI board.

7.Reinstall the rear access cover and place the server into the rack.

Page 324
Image 324
NEC 140Rc-4 manual Tab Lock for long card