High Performance Two Port 10/100 Managed Ethernet Switch with 32-Bit Non-PCI CPU Interface

Datasheet

2.2.1System Clocks/Reset/PME Controller

A clock module contained within the LAN9312 generates all the system clocks required by the device. This module interfaces directly with the external 25MHz crystal/oscillator to generate the required clock divisions for each internal module, with the exception of the 1588 clocks, which are generated in the 1588 Time Stamp Clock/Events module. A 16-bit general purpose timer and 32-bit free-running clock are provided by this module for general purpose use.

The LAN9312 reset events are categorized as chip-level resets, multi-module resets, and single- module resets.

A chip-level reset is initiated by assertion of any of the following input events:

„Power-On Reset

„nRST Pin Reset

A multi-module reset is initiated by assertion of the following:

„Digital Reset - DIGITAL_RST (bit 0) in the Reset Control Register (RESET_CTL)

-Resets all LAN9312 sub-modules except the Ethernet PHYs (Port 1 PHY, Port 2 PHY, and Virtual PHY)

„Soft Reset - SRST (bit 0) in the Hardware Configuration Register (HW_CFG)

-Resets the HBI, Host MAC, and System CSRs below address 100h

A single-module reset is initiated by assertion of the following:

„Port 2 PHY Reset - PHY2_RST (bit 2) in the Reset Control Register (RESET_CTL) or Reset (bit

15)in the Port x PHY Basic Control Register (PHY_BASIC_CONTROL_x)

-Resets the Port 2 PHY

„Port 1 PHY Reset - PHY1_RST (bit 1) in the Reset Control Register (RESET_CTL) or Reset (bit 15) in the Port x PHY Basic Control Register (PHY_BASIC_CONTROL_x)

-Resets the Port 1 PHY

„Virtual PHY Reset - VPHY_RST (bit 0) in the Reset Control Register (RESET_CTL), (bit 10) in the Power Management Control Register (PMT_CTRL), or Reset (bit 15) in the Virtual PHY Basic Control Register (VPHY_BASIC_CTRL)

-Resets the Virtual PHY

The LAN9312 supports numerous power management and wakeup features. The Port 1 & 2 PHYs provide general power-down and energy detect power-down modes, which allow a reduction in PHY power consumption. The Host MAC provides wake-up frame detection and magic packet detection modes. The LAN9312 can be programmed to issue an external wake signal (PME) via several methods, including wake on LAN, wake on link status change (energy detect), and magic packet wakeup. The PME signal is ideal for triggering system power-up using remote Ethernet wakeup events.

2.2.2System Interrupt Controller

The LAN9312 provides a multi-tier programmable interrupt structure which is controlled by the System Interrupt Controller. At the top level are the Interrupt Status Register (INT_STS) and Interrupt Enable Register (INT_EN). These registers aggregate and control all interrupts from the various LAN9312 sub- modules. The LAN9312 is capable of generating interrupt events from the following:

„1588 Time Stamp

„Switch Fabric

„Ethernet PHYs

„GPIOs

„Host MAC (FIFOs, power management)

„General Purpose Timer

Revision 1.4 (08-19-08)

22

SMSC LAN9312

 

DATASHEET