High Performance Two Port 10/100 Managed Ethernet Switch with
Datasheet
Table 6.3 Typical Ingress Rate Settings
CIR Setting | Time Per Byte | Bandwidth |
|
|
|
80 nS | 100 Mbps | |
|
|
|
4 | 100 nS | 80 Mbps |
|
|
|
5 | 120 nS | 67 Mbps |
|
|
|
6 | 140 nS | 57 Mbps |
|
|
|
7 | 160 nS | 50 Mbps |
|
|
|
9 | 200 nS | 40 Mbps |
|
|
|
12 | 260 nS | 31 Mbps |
|
|
|
19 | 400 nS | 20 Mbps |
|
|
|
39 | 800 nS | 10 Mbps |
|
|
|
79 | 1600 nS | 5 Mbps |
|
|
|
160 | 3220 nS | 2.5 Mbps |
|
|
|
402 | 8060 nS | 1 Mbps |
|
|
|
804 | 16100 nS | 500 Kbps |
|
|
|
1610 | 32220 nS | 250 Kbps |
|
|
|
4028 | 80580 nS | 100 Kbps |
|
|
|
8056 | 161140 nS | 50 Kbps |
|
|
|
After each packet is received, the bucket is decremented. If the Committed Burst bucket has sufficient tokens, it is debited and the packet is colored Green. If the Committed Burst bucket lacks sufficient tokens for the packet, the Excess Burst bucket is checked. If the Excess Burst bucket has sufficient tokens, it is debited, the packet is colored Yellow and is subjected to random discard. If the Excess Burst bucket lacks sufficient tokens for the packet, the packet is colored Red and is discarded.
Note: All of the token buckets are initialized to the default value of 1536. If lower values are programmed into the CBS and EBS parameters, the token buckets will need to be normally depleted below these values before the values have any affect on limiting the maximum value of the token buckets.
Refer to Section 14.5.3.25, on page 393 through Section 14.5.3.29, on page 398 for detailed register descriptions.
6.4.6.1Ingress Flow CalculationBased on the flow monitoring mode, an ingress flow definition can include the ingress priority. This is calculated similarly to the transmit queue with the exception that the Priority Regeneration and the Traffic Class table are not used. As shown in Figure 6.7, the priority can be based on:
The precedence bits in the IPv4 TOS octet
The DIFFSERV mapping table indexed by the IPv4 TOS octet or the IPv6 Traffic Class octet
The VLAN tag priority field (but not through the per port Priority Regeneration table)
The port default
Revision 1.4 | 72 | SMSC LAN9312 |
| DATASHEET |
|