Installation and Test for CallVisor ASAI

Expansion Interface Circuit Pack — For new multiple-port network systems or upgrades. [If you have the older TN776 circuit pack, it must be replaced with a TN570 circuit pack or later, which permits CallVisor ASAI to terminate on an Expansion Port Network (EPN)].

MultiQuest trunk for Flexible Billing

Software Installation

In addition to the CallVisor ASAI and the DEFINITY ECS basic software, the following software might be needed for your specific CallVisor ASAI installation. Refer to the DEFINITY Enterprise Server Installation and Test for Single-Carrier Cabinets, 555-230-894, or DEFINITY Enterprise Communications Server Installation and Test for Multi-Carrier Cabinets, 555-230-112, for more information.

Automatic Call Distribution (ACD) Software — For ACD configurations

Automatic Route Selection (ARS) Software — For ISDN-PRI call routing

ISDN-PRI Software — For ISDN-PRI trunks

Vectoring Basic Software — For call vectoring applications and ASAI adjunct routing

Vectoring Prompting Software — For integrated call prompting applications

Vectoring (ANI II Digits Routing)

Vectoring (G3V4 enhanced)

Vectoring (G3V4 advanced routing)

EAS Agent Skills

CallVisor ASAI Link Administration

The CallVisor ASAI software must be installed in your system before an ASAI link can be administered and activated. Up to eight ASAI links can be administered at the same time to the same or different adjunct processors using either BRI and/ or Ethernet transport.

To administer an ASAI link, use the add station command and set the link type to ASAI. Fill out the remainder of the form as appropriate for your ASAI host. CallVisor ASAI links do not support Management Information Messages (MIMs). Figure 14-1shows a sample completed Add Station form.

14-2Issue 7 May 1998

Page 372
Image 372
Lucent Technologies 555-230-220 manual Software Installation, CallVisor Asai Link Administration