•Source/Dest Name: For the Source/Dest (source/destination) names used by the system, select one of the following:

–Source name set by cross-point assignment or fixed bus name

–Description name set on routing switcher

–“Type + Num” name set on routing switcher

Names assigned with Xpt Assign can be replaced later with description names.

•Name Display: Specify the number of characters for display of the names selected in Source/Dest Name above, as two characters, four characters, or Auto.

•Flexi Pad: Carry out Flexi Pad settings. Specify the delegation selection coupling, and display mode for the LCD buttons. You can also make menu settings for wipe snapshots.

•Custom Button: Set the following button operation modes.

–[ALL] button for next transition selection

–[AUTO TRANS], [TAKE] or [FTB] button during auto transition execution

–[RUN] button during keyframe execution

–[AUTO TRANS] and [CUT] button replacement

–[TRANS PVW] button

–[UTIL] button

–[XPT HOLD] button in key rows

–Selection of signal assigned to the auxiliary bus control block key source bus (either key signal only, or either video signal or key signal selectable)

•Sensitivity: Adjust trackball, joystick and double-click sensitivity, or set the relationship between the angle of the search dial and the playback speed.

•Main Split Fader: When the split fader is active, specify whether the fader to control other than mix is the left side or the right side.

•Macro: Set the macro execution mode and the mode in which to edit macros using the standard type Flexi Pad control block.

Screen saver and other settings (Maintenance)

•Screen Saver: Make the menu screen saver settings.

•LCD Brightness: Adjust the LCD brightness.

•LED Brightness: Adjust the LED brightness.

•Switch Brightness: Adjust the switch brightness.

•Touch Beep: Select whether or not to sound a beep when a menu operation is carried out.

•Touch Panel Calibration: Calibrate the touch panel.

•Initial Menu Set: Specify the menu to be displayed at menu startup.

Switcher Setup

In switcher setup, make settings particular to the switcher processor.

198 Setup