•“Interfacing With External Devices” in “Setup Relating to Operations From the Control Panel”
•“Interfacing With External Devices (Device Interface Menu)” in “Setup Relating to DME”
•“GPI Input Settings (GPI Input Assign Menu)” in “Setup Relating to DCU”
•The available input reference signals are as follows.
Signal format | Input reference signal |
| |
|
|
|
|
| Tri Sync | Black burst |
|
|
|
|
|
1080P/59.94 | 59.94 | Black Burst 59.94 | Sync 59.94 |
|
|
|
|
1080P/50 | 50 | Black Burst 50 | Sync 50 |
|
|
|
|
Switching the signal type of DME output (video/key) assigned to a monitor signal
The function for switching the signal type of the monitor output (one channel) to video or key is assigned to one of the Prefs buttons of the Menu control block or one of the buttons of the Utility/Shotbox control block (DME MON KEY command).
For details of the assignment, see “Settings Button Assignment (Prefs/Utility Menu)” in Chapter 16 (Volume 2).
To switch the signal type of DME output (video/key) assigned to a monitor signal
Press the DME MON KEY command assigned button and turn it on to assign DME key output to a monitor signal. Then press the button and turn it off to assign DME video output to a monitor signal. For selection of the DME channels to be assigned to a monitor signal, see “Assigning a DME output signal as a monitor signal” (page 403) under “Applying a DME Effect to a Key” in Chapter 4.
Selecting the signal output from the DME monitor output connector
1 Display the Engineering Setup >DME >Output >Monitor Output menu.
2 Press [DME1] or [DME2] to select the DME to operate on.
3 On the left, select MONI OUT#1 or MONI OUT#3.
4 On the right, select the signal.
You can select any of Ch1 Video, Ch1 Key, Ch2 Video, and Ch2 Key.
246 Dual Link Support