DME: This applies a
FM1&2ClIP, FM3&4ClIP, FM5&6ClIP, FM7&8ClIP: A recorded clip is played back together with the transition. At this point, you can also carry out a background transition (wipe or mix (dissolve)) simultaneously together with the clip.
bKey transition selection buttons To insert or delete key 1 on the next transition, hold down the [KEY1] button, and select the type of transition using the transition type selection buttons. If the key is currently not inserted, the transition will insert it, and if the key is currently inserted, the transition will delete it. You can use the [KEY2] button in a similar way.
While these buttons are held down, you can select a key source with the
Pressing one of these buttons twice in rapid succession changes the state of the corresponding key bus so that a
Key delegation button | Corresponding |
(double press) | key bus |
|
|
[KEY1] | key 1 a) |
[KEY2] | key 2 b) |
a)The key bus switching button [KEY3] in the cross- point control block goes off.
b)The key bus switching button [KEY4] in the cross- point control block goes off.
cTransition execution section
Fader lever: Move this vertically to carry out a transition.
When the split fader function is enabled, by pressing the projection on the left side of the grip you can release the lock and separate the two halves of the fader lever. With the split fader
lever, in a background mix transition, you can control the background A and B buses independently.
Transition indicator: This comprises multiple LEDs, which show the progress of the transition.
Transition rate display: This displays the transition rate (the time from the beginning of the transition to its completion) set for an auto transition, in frames.
You can set the transition rate using the numeric keypad control block or menu.
TAKE button: Pressing this button carries out an auto transition of the set transition rate. The transition starts immediately, and the button lights amber. When the transition completes, the button goes off.
dWipe direction selection buttons
REV (reverse): When this button is off, the wipe proceeds in the normal direction. When the button is lit, the wipe proceeds in the reverse direction.
The normal direction refers to the black to white direction or in the direction of the arrow as shown in “Wipe Pattern List” (page 560) and “DME Wipe Pattern List” (page 566) in Appendix (Volume 1).
NORM/REV (normal/reverse): The wipe direction alternates between normal and reverse every time a transition is executed.
ePattern limit buttons
LIMIT SET: Move the fader lever to the position of a particular pattern size, and stop it there, then press this button to set the pattern limit range. This button is enabled when the [PTN LIMIT] button is off.
PTN (pattern) LIMIT: When a wipe or DME wipe is selected, pressing this
302 Names and Functions of Parts of the Control Panel