Panel Control and Menus 2 Chapter

LOCAL (DELAY): Press this button, turning it on, to enter a delay value from the numeric keypad control block.

GLB (STB OFF: standby off): Press this button to switch to standby off mode. This button cannot be used for frame memory clip operations.

SRC (REC: record): Press this button at the same time as the [Y] button to start recording. This button cannot be used for frame memory clip operations.

TRGT (STOP): Press this button to stop the tape, disk or frame memory clip.

AXIS LOC (START TC: start timecode): Press this button to set the timecode of the start point at that time. The timecode of the start point is updated to the current time each time this button is pressed.

When the device the operation applies to is a VTR/disk recorder, the start point updated by the setting of the [MENU] button is as follows.

When the [MENU] button is On: start point of the timeline

When the [MENU] button is Off:

start point of Cueup & Play

ASP PERS (STOP TC: stop timecode): Press this button to set the timecode of the stop point at that time. The timecode of the stop point is updated to the current time each time this button is pressed.

When the device the operation applies to is a VTR/disk recorder, the stop point updated by the setting of the [MENU] button is as follows.

When the [MENU] button is On: stop point of the timeline

When the [MENU] button is Off: stop point of Cueup & Play

LOC SIZE (VAR: variable speed playback): Pressing this button and turning the Z-ring plays back the tape, disk or frame memory clip at a variable

speed and direction proportional to the rotation angle of the Z-ring. The variable speed range is –1 to +3 times normal playback speed.

LOC XYZ (SHTL: shuttle): Pressing this button and turning the Z-ring plays back the tape, disk or frame memory clip at a speed and direction proportional to the rotation angle of the Z-ring.

ROT (JOG): Pressing this button and turning the Z-ring plays back the tape, disk or frame memory clip at a speed and direction proportional to the rotation of the Z-ring.

CLR WORK BUFR (CUE): Pressing this button cues the tape, disk or frame memory clip automatically to the start point.

X (REW: rewind): Press this button to rewind the tape, disk or frame memory clip.

Y (PLAY): Press this button to play the tape, disk or frame memory clip.

Z (FF): Press this button to fast forward the tape, disk or frame memory clip.

CTR (ALL STOP): Press this button to stop all tape transport/disk drive/frame memory operations.

When the resizer control mode is enabled (for the MVS-8000G only)

LOCAL (K1): Select key 1.

GLB (K2): Select key 2.

SRC (K3): Select key 3.

TRGT (K4): Select key 4.

LOC SIZE (ASP: aspect): Pressing this button and operating the trackball or Z- ring changes the aspect ratio of a key to which the resizer function is applied to. When this button is held down, the trackball or Z-ring operation is switched to a finer control. (fine mode)

LOC XYZ (LOC: location): Pressing this button and operating the trackball or Z-

274 Names and Functions of Parts of the Control Panel