Knob | Parameter | Adjustment | Setting values |
|
|
|
|
2 | V Size | Tile height | 0.00 to 100.00 |
|
|
|
|
3 | Volatility | Rate of tile generation | 0.00 to 100.00 |
|
|
|
|
•When a diamond dust wipe is selected (pattern number 274)
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
1 | H Size | Particle width | 0.00 to 100.00 |
|
|
|
|
2 | V Size | Particle height | 0.00 to 100.00 |
|
|
|
|
3 | Flash Rate | Rate of generation of particles | 0.00 to 100.00 |
|
|
|
|
Note
When Flash Rate is set to 0.00, you cannot change the pattern. In this state, adjusting H Size or V Size has no effect on the pattern.
For details of a pattern mix, see the next section.
For details of applying pattern modifiers, see “Setting Wipe Modifiers” (page 443).
Selecting a wipe pattern in the Flexi Pad control block
To select a pattern with a standard type Flexi Pad control block, use the following procedure. (It is not possible to select a wipe pattern with a simple type Flexi Pad control block.)
1 In the
This switches the Flexi Pad control block to wipe snapshot mode.
2 In the memory recall section, press the [PTN NO] button.
440 Basic Procedure for Wipe Settings