•When you move the fader lever, the transition is carried out from the pattern limit state to the state before the pattern limit transition was carried out.
Moving the fader lever even a little synchronizes the fader lever position with the transition state, and you can move the fader lever either in the forward direction or in the reverse direction.
Depending on the Setup settings, the transition may be executed at the instant you press the [PTN LIMIT] button, and the button goes off. In this case, execution continues for the time specified by the dedicated transition rate in the menu setting, as far as the state of the next transition.
For details of the setting, see “Settings Relating to Keys, Wipes and Frame Memory (Key/Wipe/FM Menu)” in Chapter 16 (Volume 2).
To set the transition rate when the pattern limit is released
1 In the <Pattern Limit Release> group of the Edge/Direction menu, select one of the following.
Auto Trans Rate: Use the transition rate set in the transition rate control block
Independ Trans Rate: Independent transition rate
2 If you selected “Independ Trans Rate” in step 1, adjust the following parameter.
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
1 | Transition Rate | Independent transition rate | 0 to 999 (frames) |
|
|
|
|
358 Executing a Transition