For a pattern in one-channel mode: in the <Ch Select> group, press [1st Ch], turning it on.

For a pattern in two-channel mode: from the <Ch Select> group, select the corresponding channels. You can select more than one channel at the same time.

3 In the <Crop Mode> group, press [Crop] or [4:3 Crop] (to crop from 16:9 to 4:3 aspect ratio), turning it on.

4 In the <Crop Mode> group, press [Remove From Begin].

The Remove From Begin menu appears.

5 In the <Crop Transition> group, select the execution mode for the DME wipe crop transition.

Cut: Cut mode. The cropping does not change during the transition, but at the end point of the transition the cropping is removed (enlarges).

Last 5%: The cropping is maintained for the first 95% of the transition, and is progressively removed during the last 5% of the transition (enlarges).

Linear: The cropping is removed linearly through the whole course of the transition (enlarges).

 

Transition

 

Transition

 

 

 

Transition

 

 

 

 

 

 

Cropping

 

Cropping

 

 

 

Cropping

y

y

y

(%)

 

(%)

 

 

(%)

 

 

 

100

 

100

 

 

100

 

 

 

 

 

 

 

 

 

 

 

95

 

 

 

 

 

 

 

 

 

 

 

 

 

 

0

 

t

0

 

t

0

 

t

 

 

 

100 (%)

95 100 (%)

100 (%)

 

 

 

 

[Cut]

 

[Last 5%]

 

[Linear]

t: transition execution time

y: change in transition and cropping amount

Setting the timing of transition completion

When the execution mode for a DME wipe crop transition is set to [Last 5%], you can select the timing of transition completion from 70% ([Last 30%]), 95% ([Last 5%]), and 100% ([Off]).

Wipes DME 6 Chapter

Basic Procedure for DME Wipe Settings 475