Examples of Operations in the Multi Program 2 Mode (When Sharing a Switcher Bank)

To create video on the M/E or PGM/PST bank assigned to both main and sub operations, use the following procedure.

1 Press the [MAIN] button, turning it on, and turning off the [SUB] button. 2 With the normal operations, create the main video.

3 Press the [SUB] button, turning it on, and turning off the [MAIN] button.

Now you can create the sub video.

4 Create the sub video.

The basic method of operation is the same as for the main video, except that the utility 2 bus signal is assigned to background A, and the utility 3 bus signal is assigned to background B.

For sub, only keys 2 to 4 can be used, and for wipes, standard wipe patterns only. There are also other differences in operation from standard mode.

For details, see “Differences Between Multi Program 2 Mode and Standard Mode” (page 242) and “Restrictions on Using Multi Program 2 Mode” (page 243).

5 Press the [MAIN] and [SUB] buttons simultaneously, turning them on.

If both buttons are lit, the control panel shows the status of main.

6 Carry out the transition.

Both main and sub video images are switched.

Optional Operations

Making cross-point settings

Cross-point assign tables can be set not only for main output but also for sub output.

You can set cross-point assign tables for the following banks. M/E-1 SUB to M/E-3 SUB

P/P SUB

The table actually used is that for which the control panel delegation button is lit.

Functions 8000-MVS 1 Chapter

Multi Program 2 237