Note

This setting is cleared when you reset the control panel.

Assigning a button to the function of disabling cross-point button operation

You can assign the button to be used for the operation to the [PRE MCRO] button, in setup. (See Chapter 16, “Overall Control Panel Settings (Config Menu)” (Volume 2))

You can also use the [Inhibit Set] and [Inhibit All Clear] functions, assigned to user preference buttons. (See Chapter 16, “Setting Button Assignments (Prefs/ Utility Menu)” (Volume 2))

Buses for which operations can be inhibited

This setting applies to the AUX control block and switcher bank cross-point buttons.

For example, if you make the setting for one cross-point button in a switcher bank, this inhibits operation of all cross-point buttons with the same number in the following buses.

The corresponding name also disappears from the source name display.

•Background A, background B

•Keys 1 to 4

•Utility 1, utility 2

•DME utility 1, DME utility 2

•External DME

To inhibit operation of a cross-point button

Hold down the button which “Inhibit Set” is assigned, and press the cross-point button whose operation you want to inhibit.

The button you pressed flashes amber, and this makes the operation inhibited.

Note

Even when you inhibit operation of a cross-point button, macro attachment settings are still possible (see page 218).

To clear a cross-point button operation inhibit setting

Hold down the button to which “Inhibit Set” is assigned, and press the button whose operation is inhibited (flashing amber).

This clears the operation inhibit setting for the button you pressed.

To clear all operation inhibit settings

Press the button to which “Inhibit Set” is assigned and the button to which “Inhibit All Clear” is assigned simultaneously.

32 Signal Selection