Memory Frame 7 Chapter

Still Image Operations

For an overview of frame memory concepts, see “Frame Memory” (page 85).

Notes

•During playback of a frame memory clip of the pair assigned to either of the target FM selection buttons (see page 514), frame memory operations may not be performed properly. Carry out frame memory operations after stopping clip playback.

•The following sections describe the operations available in the MVS-8000A system and MVS-8000G system.

The MVS-8000 system uses the same menus as those of Version 5.30. For its operating procedures, see the User’s Guide of Version 6.00 or earlier.

Preparations

Allocating the frame memory outputs (FM1 to FM8) to crosspoint buttons

To output a frame memory image to a monitor, for example, the output signal from the frame memory (FM1 to FM8) must be allocated to a cross-point button. Carry out this allocation in the Setup menu.

Accessing the Frame Memory menu

Most frame memory operations are carried out using the Frame Memory menu. To access the Frame Memory menu, use either of the following procedures.

•In the menu control block, select the top menu selection button [FRAME MEM].

•Press the cross-point button to which the frame memory output is allocated twice in rapid succession.

Interpreting the Frame Memory Menu

The menu screen consists of the following principal parts.

The frame memory selection area display is the same for all except the Pattern Adjust/Pattern Select/Field Invert/File (excluding Pair Recombination menu)/ Folder/External HDD menus.

490 Still Image Operations