Panel Control and Menus 2 Chapter

control block. In this state, the [M/E 1] to [M/E 3] buttons, [P/P] button and [DME1] to [DME8] buttons function as the device 1 to device 12 allocation buttons as follows.

[M/E1] (DEV1): device 1

[M/E2] (DEV2): device 2

[M/E3] (DEV3): device 3

[P/P] (DEV4): device 4

[USER] (FM1CLIP): frame memory clip 1

[Unused] (FM2CLIP): frame memory clip 2

[DME1] (DEV5): device 5

[DME2] (DEV6): device 6

[DME3] (DEV7): device 7

[DME4] (DEV8): device 8

[Unused] (FM LOOP): frame memory loop

[DME5] (DEV9): device 9

[DME6] (DEV10): device 10

[DME7] (DEV11): device 11

[DME8] (DEV12): device 12 To exit from this mode, press the [DEV] button again, turning it off.

When the [RUN CTRL] button is selected: This enables the effect run control mode in the device control block.

When the [RSZR CTRL] button is selected: This enables the resizer control mode in the device control block of the MVS-8000G.

For details on resizer, see page 419.

The functions of the operation buttons, trackball, and Z-ring vary with the operation mode as follows.

bOperation buttons

When the positioner operation mode is enabled

K1 CB1: Press this button to enable wipe pattern position setting for key 1

(DSK1).

When the [USER] button is selected, pattern position setting for color background 1 is enabled.

K2 CB2: Press this button to enable wipe pattern position setting for key 2 (DSK2).

K3: Press this button to enable wipe pattern

position setting for key 3 (DSK3).

K4: Press this button to enable wipe pattern

position setting for key 4 (DSK4). MAIN: Press this button to enable main

wipe pattern position setting for normal transitions.

SUB: Press this button to enable sub wipe pattern position setting for normal transitions.

Among the [K1 CB1] button, [K2 CB2] button, [K3] button, [K4] button, [MAIN] button, and [SUB] button, you can select multiple buttons.

POS: Press this button to enable pattern movement in the x-axis and y-axis directions with the trackball.

When the [USER] button is selected, this enables the trackball to move the pattern in the x-axis and y-axis directions, and the Z-ring to adjust the size of the pattern.

X, Y: These restrict the axes affected by the trackball and Z-ring to the x- or y-axis.

Z:This restricts the axes affected by the trackball and Z-ring to the z-axis.

CTR (center): When this button is pressed, the pattern position returns to the center. When the [USER] button is selected, the pattern size also returns to 50.00.

SHIFT/CLR WORK BUFR: Press this button twice in rapid succession to reset all parameters on the target M/E or PGM/PST to their initial values.

272 Names and Functions of Parts of the Control Panel